This male–female 40-pin jumper wire set makes connecting sensors, modules, and breadboards effortless. Use them to link female headers on Arduino boards to breadboards, or interface male module pins to jumpers cleanly.
Each ribbon is peel-apart for neat cable management, and the assorted colours help trace signals quickly. Perfect for classrooms, makerspaces, or rapid prototyping.
Quick Use Ideas
Connect Arduino female headers to breadboard circuits.
Bridge sensors, drivers, and logic modules to GPIO pins.
Group leads for I²C, SPI, or serial communication harnesses.
Tip: Combine male–female sets with male–male jumpers for full prototyping flexibility. Label or colour-code your signal types to debug faster.
Warning: Designed for low-voltage DC applications only. Avoid pulling from the wire insulation—grip by the connector ends for longer life.
Technical Specifications
Operating Voltage
3.3 V – 5 V DC
Channels
3 (independent, adjustable)
Outputs
3× Digital (active level varies by board)
Sensing Elements
IR LED + Phototransistor (per channel)
Detection Distance
Approx. 2–15 mm (surface-dependent)
Indicators
Per-channel status LEDs
Adjustments
3× trim-pot threshold controls
Connector
VCC / GND / D1 / D2 / D3
Recommended Use
Educational, R&D or hobbyist environments only
Product Details
Safety & Compliance
Statement
For educational laboratory and R&D use only.(non-RoHS).
WEEE
Not subject to WEEE marking; obligations apply to final equipment.
Manufacturer
Little Muffins Things Limited
166 River Heights, 90 High Street
London E15 2GQ littlemuffinsthings.com